+8618137782032
Search
enLanguage

Mould design for Aluminum for building

Dec 01, 2020

Mold design,Aluminum for building diversion hole and diversion hole design: when designing the mold, Aluminum for building the diversion hole and diversion hole position should be evenly distributed,Aluminum for building so that each part of the profile can absorb the same amount of metal. The size of the diversion hole and the diversion hole is proportional to the area of the profile.

Without affecting the strength of the mold and the surface quality of the profile,Aluminum for building try to make the diversion hole and the diversion hole as large as possible. When the metal flows into the welding chamber,Aluminum for building the guide The larger the flow orifice and the diversion hole, the smaller the force on the bridge area. The displacement of the metal flow from the bridge will reduce the resistance and increase the discharge speed,Aluminum for building but it does not affect the strength of the mold.

Therefore, a mold with a small feed hole and a large bridge may not have better strength than a mold with a large feed hole. Bridge location design: The bridge location is an important part of the mold organization. It is the support bridge of the mold. When designing the mold bridge location,Aluminum for building it must be considered that it has enough support for the mold. In order to meet the support strength of the mold,Aluminum for building the bridge position angle is generally designed to be between 18-25°C, too large an angle will increase the friction between the metal flow and the bridge position,Aluminum for building and slow down the flow of the metal flow. The smaller the angle,Aluminum for building the easier the welding of the metal. Close, the discharge speed will increase accordingly.

At the same time,Aluminum for building the design of the bridge position angle junction should be as smooth as possible to avoid or reduce the dead angle of welding. Welding room design: The welding room should not be too deep. Too deep of the welding room will increase the metal volume in the welding room.

When the volume of the welding room increases,Aluminum for building the welding process will also lengthen, and the extrusion pressure will increase accordingly. Working belt design: The mold working belt should be polished carefully to ensure flatness and verticality, and no turtles or unevenness,Aluminum for building reasonable calculation of the working belt length,Aluminum for building uniform metal flow.


Send Inquiry